.060 Ball End Mill – 4 Flute

Bought this to engrave curved lettering into some 304 stainless and the ball tip leaves a really clean rounded profile without chatter. The .060 diameter is small enough for fine detail work but the solid carbide holds up way better than the HSS bits I was burning through before.

The 4-flute geometry clears chips way better than the 2-flute bits I used before, so I'm not stalling out halfway through a cut. Ball nose leaves a nice smooth radius on the curved pockets I'm milling in stainless.

Bought this for engraving curved details on a stainless steel project and the 4 flutes left a really clean finish. The .060 ball tip handled the tight radii better than the flat end mills I've been using. Held up fine after a couple hours of cutting.