.085 Square End Mill – 2 Flute

Bought this for cutting clean square pockets in aluminum plate and the .085 tip leaves nice sharp corners. The 1/8 shank fits my trim router collet perfectly, no wobble at all. Two flutes clear chips well enough that I'm not stopping to vacuum every pass.

Plowed through a stack of walnut knife scales without any chatter, and the 2-flute geometry cleared chips way better than the 4-flute bits I used to run. The 1/8" shank dropped right into my trim router's collet with no adapter needed.

Cut cleaner edges on my brass spacers than the two-flute I was using before, and the .085 tip is perfect for the narrow slots I need. The 1/8 shank drops right into my standard collet with no fuss.