.010 Ball End Mill – 2 Flute

I picked this up for cutting rounded slots in a small walnut project, and the 1/8 inch shank dropped right into my trim router with no adapter needed. The two flutes clear chips surprisingly well at slow feed rates, though you definitely have to go easy or the tip will snap.

The .010 ball tip leaves a clean radius on the curly walnut inlays I've been cutting, and the 1/8" shank drops straight into my trim router with no adapter. Only ran it a few hours so far but it's holding an edge way better than the cheap set I had before.

Finally getting those tiny curved details done without chattering; the .010 tip is unbelievably precise on this solid carbide body. The 2-flute design clears chips nicely even in tight slots, and the 1/8" shank holds firm in my collet. Just wish the flutes were a bit longer for deeper cuts, but for