.009 Ball End Mill – 2 Flute

The .009" tip is tiny but holds up fine in walnut, no chipping after a dozen passes. I use it for smoothing the tight inside curves on my little box lids and it leaves almost no sanding to do.

Cut a batch of small radius details in walnut and the 2-flute design cleared chips way better than the straight bits I'd been fighting with. The 1/8" shank fit my trim router collet with no wobble at all.

That .009" tip is tiny but it held up fine cutting tight inside curves on walnut. Ran it at a slow feed and got clean walls with almost no sanding after. Two flutes cleared chips well even in the deeper passes.