.080 مطحنة نهاية كروية عميقة القطع بطول قطع .750″

That extra long flute is exactly what I needed for cutting deep pockets in aluminum without the shank rubbing. The .080 ball tip leaves a nice smooth radius on the floor of the cavity. Only ran it at moderate speeds so far, but the carbide feels solid.

I've been pushing this thing through some pretty deep pockets in aluminum and the long flute length hasn't chattered on me once. The ball tip leaves a nice smooth radius too. For a 1/8 shank tool it holds up way better than the cheap ones I used to burn through.

The 0.750" cut length lets me reach the full depth of these ball pockets in one pass instead of stepping down. Finish on the radius came out smooth in aluminum, no chatter even at that overhang.