.005 Square End Mill – 4 Flute

Been using this for tiny detail work in brass and the .005 cut width holds up way better than I expected. The 1/8-inch shank drops right into my standard collet with zero fuss. Four flutes and it still clears chips fine at slow feeds.

I was nervous about snapping a cutter this small, but the .005-inch tip has held up fine through several detail passes on aluminum. The 1/8-inch shank drops straight into my standard collet with no fuss. Four flutes leave a noticeably cleaner floor than the two-flute bits I used before.

Got this for some ultra-fine detail work on brass, and the .005 tip is genuinely as precise as advertised. The 1/8-inch shank fit my standard collet without any wobble, and four flutes kept the cut surprisingly smooth at slow speeds.