.125 Ball End Mill – 4 Flute

The 4-flute design clears chips way better than the 2-flute bits I used before, so I'm not stopping to blow out the cut every few seconds. Ran it through some stainless plate at a slow feed and the ball tip left a clean radius with no chatter. Solid carbide at this price is hard to beat.

Bought this for engraving curved details on a stainless project and the ball tip tracked beautifully with no chatter. The 1/8 shank fit my collet perfectly and the carbide held an edge through the whole run.

Bought this to mill curved slots in a stainless plate and the 4 flutes left a really clean finish. The 1/8 shank chucked up tight in my collet with no wobble, and the ball tip handled the contour passes without chattering.