.007 Square End Mill – 2 Flute

Needed a 2 flute cutter for squaring up small pockets in aluminum and this one held a clean edge through the whole job. The 1/8" shank fit my collet without any wobble, and the flat tip left the slot bottoms nice and true.

That .007" tip is genuinely tiny and it held up way better than I expected on a batch of brass slots. Two flutes cleared chips fine at 1/8" shank speeds, and the flat bottom left a clean finish.

I needed something tiny for cutting small slots in aluminum and this 2-flute carbide bit handled it way better than the cheap ones I'd been burning through. The 1/8" shank fits my trim router collet perfectly, and the flat tip leaves a clean floor on pockets.