.023 Ball End Mill – 2 Flute

Bought this for cutting small curves in walnut and the 2 flutes clear chips way better than the 4-flute I had before. Solid carbide holds an edge nicely, and the 1/8 shank drops right into my trim router. Only gripe is the tip is fragile if you push too hard.

That .023" tip is tiny but holds up great in walnut, and the 1/8" shank fits my trim router without any adapter. Clean cuts on curved inlays, no chatter even at higher speeds.

Bought this for cutting fine 3D reliefs in walnut and the 1/8" shank fits my trim router perfectly. Two flutes clear chips well and the ball nose leaves almost no sanding marks on curves.