.007 Ball End Mill – 2 Flute

Picked this up for milling tight curved details in walnut and the .007" tip is perfect for getting into those little radius pockets without leaving chatter marks. The 2-flute geometry clears chips really well, I barely had to pause to vacuum the cut. Solid carbide, still sharp after a few hours of c

That .007" tip cuts detail I honestly didn't think a 1/8 shank tool could hold, and the ball nose leaves a smooth finish on contoured pockets. Two flutes clear chips well enough that I'm not stopping to re-cut every pass.

Used this for milling fine curved details in aluminum and the 2-flute design clears chips way better than my old 4-flute. The 1/8 shank fit my router collet perfectly. Solid carbide, still sharp after a few hours of cutting.