.016 مطحنة نهاية مربعة عميقة القطع بطول قطع .150″

I was worried a .016 cutter would snap on my first deep pocket, but it chewed through aluminum plate with no chatter at all. The .150 cut length let me reach the full depth in one pass instead of stepping down like I used to.

That extra long flute length is exactly what I needed to reach the bottom of deep pockets without the shank rubbing. The .016 tip leaves a clean square corner in aluminum, and the 1/8 shank fit my collet perfectly.

Grabbed this for cutting deep slots in aluminum and the .150 inch cut length actually gets me down where I need to go without swapping bits. The .016 tip is tiny, so go slow and light on the passes or it'll snap, but it held up fine once I dialed it in.