.005 مطحنة نهاية مربعة طويلة الوصول مع وصول 1.9 مم

The relief grind behind the flutes is the real win here, no rubbing or chatter even when I'm buried deep in a slot. Carbide this small usually snaps on me, but the 1/8 shank feels solid in the collet and the .005 tip cut clean.

That 1.9mm reach got me into a pocket I couldn't touch with any of my standard-length cutters, and the relief grind behind the flutes kept it from rubbing. It's a fragile little thing at .005, so I run it slow, but it's held up fine through a couple dozen passes.

I needed to cut some deep 0.005" slots in aluminum and the 1.9mm reach on this actually got me there without rubbing the shank. Runout on my 1/8" collet was basically zero, and the square tip left clean corners. For the price I'll grab a couple spares.