14° Incra 鳩尾榫銑刀 x 17/32英吋切削直徑 – Whiteside D14-531

Cut this bit through some hard maple for drawer sides and the 14° angle cut smooth as butter with no tear-out. The 17/32″ diameter gave me exactly the joint depth I needed for my box project.

Cut through a full sheet of 3/4" plywood test pieces and the 14° angle came out crisp on every single tail, no burning even at a moderate feed rate. The 17/32" diameter makes for a solid, meaty joint that feels almost too tight on the first dry fit, which is exactly what I want.

The shank fit perfectly in my router collet with zero wobble, and the finished dovetail joints came out tight and clean on the first test cut. I've been through a few bits, but this one really holds an edge through a full set of drawers.