22.5° 斜角倒角銑刀 x 7/8″ 切削高度 – Whiteside 2307

That 22.5° bevel is exactly what I needed for my raised panel edges, and the cut height handled the whole depth in one pass. Clean, smooth cuts with zero burning even on hard maple.

The 7/8" cut height gave me enough depth to chamfer the edge of a thick maple tabletop in one pass. Cuts were glassy smooth right off the bit, no burn marks or tearout even on end grain. I've used cheaper chamfer bits that chattered, this one just doesn't.

The 22.5° angle is perfect for softening the sharp edges on my walnut sofa table without going too aggressive like a 45 would. The 7/8" cut height let me bury it in the router table and still get a full bevel in one pass. Cuts were glass smooth right off the bit, no sanding needed.