7°斜角倒角銑刀 x 3/8吋切削高度 – Whiteside 2298（AstraHP塗層）

Took a chance on this bit for some oak shelving edges, and the 7° bevel is consistently sharp from start to finish. The 3/8-inch cut height is just right for a subtle detail without being overwhelming.

Used it to put a light chamfer on the inside edges of some cabinet face frames and the cut came out glassy smooth with zero tearout. The 3/8" cut height gives me just enough bite for that without hogging off too much material. Coatings still look new after a couple dozen passes.

The 7° angle is subtle enough that it just breaks the sharp edge without looking like a big cut, which is exactly what I wanted on my drawer fronts. The AstraHP coating seems to keep it slicing cleanly through hard maple without any burn marks.