6面または12面バーズマウスルータービット – Whiteside 3506

The cut is so clean I barely had to sand the edges on my first six-sided planter. It took a while to dial in the depth, but once I did, every joint seated tight without gaps. Exactly what I needed for quick, accurate joinery.

Bought the 12-side version for a cedar planter project and the cuts came out clean enough that hardly any sanding was needed. Carbide stays sharp after a few dozen passes through hard maple. Setting the depth took a little trial and error on scrap first, but once dialed in it was repeatable.

The 6-side cutter dropped right into my router table and cut clean birdsmouths on the first try, no chatter at all. The angle is dead accurate, so my staves close up tight with barely any gap to fill.