45° بتة شطف بقطر 7/16 بوصة ارتفاع القطع – Whiteside 2305

The carbide tips leave a really clean edge on hard maple, way less tearout than the cheap bit I had before. Two flutes cut fast and it stayed sharp through a whole batch of picture frames. The 7/16" cut height is perfect for the stock I'm working with.

Bought this to chamfer the edges on some oak shelving and the cut height was spot on for the 3/4" stock I was using. The carbide tips have held up through a few hundred linear feet without any tearout. Mitered corners came out dead tight.

The two flute carbide tips leave an incredibly clean edge on the white oak picture frames I've been building. I used it to cut 45s for mitered corners and the joints closed up tight with almost no sanding needed.