بت Roundover 1/2 بوصة × ساق 1/2 بوصة – Whiteside 2009

Cut a dozen test pieces this afternoon and every single edge came out silky smooth with zero chatter, even on some gnarly oak end grain. The 1/2-inch radius is exactly what I needed for these cabinet doors, no tear-out whatsoever.

The 1/2″ shank sits rock-solid in my collet, zero chatter even on a fast pass with oak. I ran it along a walnut shelf and the 1/2-inch radius left a glassy finish I didn't have to sand. This one's earned a permanent spot in my go-to drawer.

Went through a few cheaper bits before trying this one, and the carbide cuts so cleanly it barely leaves any tear-out even on oak. The 1/2-inch shank gives it zero vibration in the router table, which makes a huge difference for a smooth finish.