5件深槽口路由器位元組 – Whiteside 1960

I was nervous about tear-out on some hard maple, but these bits left an almost glass-smooth finish. The deep cutting depth saved me from multiple passes, and the bearings ran true right out of the box.

These bits cut through 3/4" plywood in a single pass without any burning, which saved me a ton of time on the last set of shelves. The carbide edges are still razor sharp after running through about 40 feet of hardwood.

I needed a deep rabbet for cabinet doors, and the carbide-tipped bits in this set cut through plywood without any burning. Each bit stays sharp and the bearings run smooth, which saves me a lot of sanding time.