3/4″ Compression Spiral Flush Trim Router Bit – 1/2″ Shank (AstraHP Coated)

Overview

The 3/4″ compression flush trim bit is built for heavy material and demanding flush trim work. The compression geometry (up-cut flutes below, down-cut flutes above) produces clean edges on both faces of your material simultaneously, eliminating tearout on veneered panels, laminates, and hardwood plywood.

What sets this bit apart is the top and bottom bearing design. Use it as a standard flush trim bit with your template below the workpiece, or flip your setup and run it as a pattern bit with the template above. One bit handles both configurations — no bit change needed when you switch setups on the router table.

For thicker material that exceeds the 1-3/8″ cut length, both bearings are removable. With the bearing removed, the full cutter height is exposed; rough cut your workpiece to within 1/8″ of the cut line before removing the bearing and making your final flush pass. Skipping the rough cut risks overloading the bit and leaving a poor edge.

The 1/2″ shank requires a full-size router or router table.