.093 Diepsnijdende bolfrees met snijlengte .750″

Wasn't sure a 1/8 shank would hold up to the deep pockets I needed, but that .750 cut length got me all the way down in one pass. Finished the whole batch of aluminum parts without a single chatter mark.

The extra long flute on this .093 ball end mill let me cut 3/4" deep pockets in one pass without the shank rubbing. Runout was basically zero on my little router, and the finish in hard maple came out glassy.

Needed a ball end mill that could reach deeper pockets without losing rigidity, and this one’s extra-long flute length did the trick on my last job. The .093 cutting diameter held up through several passes in steel without deflection I could notice. Solid carbide feels substantial—no chatter marks o