3/4″ Ovalkanten-Fräser – Whiteside 1476

That 3/4-inch bit cut through a piece of oak without any burning or chatter, leaving a smooth oval profile that needed almost no sanding. I’m really impressed with how clean the exit hole looked on the end grain.

I’d been chasing the same smooth curve on a set of oak shelves for days, and this bit finally gave me that clean, consistent oval profile in one pass. The 3/4-inch cutting edge handles the bullnose shape beautifully, and the finish came out so clean I barely needed to sand.

The 3/4-inch width is perfect for tabletops, and it leaves a clean oval profile with zero chatter marks on oak. I ran it through a few test pieces at full depth and the bearing tracked smoothly the whole way, no burning even on end grain.