Ogee Stile and Rail Bit Set for Cabinet Doors

Quick answer

The Whiteside 6002 Ogee Stile and Rail Router Bit Set lets you cut interlocking joints and a raised panel groove in one pass on your router table.

Step-by-step setup and use

1. Install the bits: Insert the stile bit into your router collet and tighten securely. Repeat for the rail bit. Use a router table for better control. Check that the collet is clean and the bit is fully seated to avoid runout.
2. Set the fence and height: Position the fence so the bearing rides against the workpiece edge. Adjust bit height so the cutter engages the full thickness of the stock. Test on scrap first; the reveal width is fixed at 3/8 inch, so fence position is critical.
3. Cut the stiles: Run each stile piece past the stile bit, keeping the workpiece flat and against the fence. Use a featherboard for safety. Feed direction must be against the bit rotation to prevent kickback.
4. Cut the rails: Switch to the rail bit and cut the rail ends. The interlocking profile will mate with the stile groove. Ensure rail stock is exactly the same thickness as the stiles for flush joints.
5. Assemble the door frame: Apply glue to the tongue and groove, then press the rails into the stiles. Clamp square and check for 90-degree corners. Wipe off excess glue immediately; the ogee profile can trap dried glue.

Product facts

• Ogee Stile and Rail Router Bit Set – Whiteside 6002: The Whiteside 6002 has a 1/2-inch shank, 7/8-inch cut length, and cuts a 3/8-inch reveal width with a 1-5/8-inch large diameter. The large diameter and 1/2-inch shank provide stability and smooth cuts on hardwood cabinet doors, reducing chatter.