لقمة روتري دائرية غاطسة 3/8 بوصة × ساق 1/2 بوصة – مطلية بأسترا – وايتسايد (2058)

Being able to plunge this roundover bit into the middle of a panel to start the cut is a real time-saver, and the Astra coating on the 1/2-inch shank has kept it sliding through hard maple without a hint of burn.

The flat-bottom cut is exactly what I needed for a set of cabinet doors, and the plunge action made the whole job feel controlled and precise. The 1/2″ shank gave me zero chatter even on some gnarly grain, and the edge came out clean enough that I barely had to sand.

The plunge feature let me start the roundover mid-board without a pilot hole, which saved setup time. The Astra coating seems to be keeping the carbide clean so far, though I’ve only run it through oak.